Last Topic "Security Executable"

Temp Codes for Security.exe

Dealers may choose to use a temporary code prior to receiving the physical security key (dongle). The advantage to using a temp code in lieu of a security key is it will expedite the programming process. Enter the temp code by:

  1. Right click on the security key icon (located in the systray).

  1. Click on the “Enter Temporary Code” on the pop up screen.

  1. Enter code in field box, press “OK” button.

You will need to attach the security key when in final possession. The system will continue to use the temp code even after the security key is attached. It is important to use the following instructions to verify the system is operating with the live key:

  1. Right click on the security key icon (located in the systray).

  2. Click on the “Remove Temporary Code” on the pop up screen.

A green check mark should indicate the new security is recognized. If it is not recognized try the following steps:

  1. Remove key and restart security (x:\rmwin\security.exe)

  2. Right click on the security key icon on the systray and verify the “Key Status” as "key not found"

  3. Close ASI Security

  4. Restart security (x:\rmwin\security.exe)

  1. Right click on the security key icon (located in the systray).
  2. Click on the “Enter Temporary Code” on the pop up screen.
  3. Enter code in field box, press “OK” button.

  1. Exit security and reconnect key

  2. Restart security (x:\rmwin\security.exe)

A green check mark should indicate the security key is recognized.

Note: Open a support ticket (dealers only) if these steps should fail and continue to use the temp code to keep the system running

Resellers obtain the temp code by going to the Patches and Utilities page on the reseller web site and select the “Daily Security Code” hyperlink.

 

Next Topic "Centralized Program Control (RMStart.exe)"